Posted: Sun Mar 07, 2010 3:51 pm Post subject: Graphics Issues
This is really about two problems:
1) When I use the CCstarter uitlity to disable direct draw and boot up CC2, the intro is fine (i.e. the circular motion doesn't take forever). However, once I get in-game, it gives me the old "can't access surface for lock error." What gives? It seems to me like directdraw was disabled, for a whole two seconds, then it comes back on again. What's going wrong here?
Side note: when I normally start the game with direct draw on (It can't be turned off manually with my video card) there is no "can't access surface for lock" message, just the characteristic lag.
2) After this happened with all the CC Games, I decided to start in safe mode and play; perhaps that would fix it. Lo and behold, it did. All the CC games ran marvelously...except for sound. I realized that the problem was my video drivers. I booted normally and disabled my newer video drivers reverting back to the Standard VGA adapter and the game gives me a "Display is not supported on your card blah blah nonsense" when I just played it on the same adapter five minutes ago.
Long story short, a fix in any one of these two areas would allow me to play CC in its full, un-laggy glory and would be much appreciated. Thanks in advance.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
In August of 2004, Zappi, Homba, Bambam887, RedScorpion and MOOXE all pitched
in to create this Close Combat site. I would to thank all the people who have visited
and found this site to thier liking. I hope you had time to check out some
of the great Close Combat mods and our forums. I'd also like to thank
all the members of our volunteer staff that have helped over
the years, and all our users that contributed to this site!